The installation of ceiling downlights is an essential part of the entire home lighting. If the led downlights do not work. how to change a new light. below are the method and procedure.

1. prepare the tools for repairing and replacement. electrical tape and a new led downlight with same hole size or same model. A set, pliers, and a small hand saw if necessary.
2.  Turn off the power and slowly buckle down the lamp. Pay attention to the reed clip on the lamp. After you see it, hold down the lamp with your finger, If you don’t pay attention to the reed card, you will be injured by the reed card if you pull the lamp head straight down, so be careful to remove the old bad led downlight.
3. Then first disassemble the connector, replace the lamp head, the driver does not move, turn on the light switch, if the light is not on, you can confirm that it is the driveIf the drive is faulty, replace the drive.
4. Then first disassemble the connector, replace the lamp head, the driver does not move, turn on the light switch, if the light is not on, you can confirm that it is the driveIf the drive is faulty, replace the drive.
5. Wrap one of the driver power cords on one of the lamp power cords (lighting electricity is irrespective of positive or negative), and use bakeliteThe tape is glued, and the other one is connected in the same way and wrapped with electrical tape.
6.  ​​It is about to be completed. Next, power up the experiment. Turn on the switch and the light will turn on. If it does not turn on, repeat the above steps but it is not a replacement drive.